30 Full active operating mode
With the use of control 30 the amplifier is operating in
full active mode. Set the switch on position 2. In this
case the frequencies of input A and B (only this can be
used in full active mode) are set for channel A and B.
The lowpass of the signal's adjusted frequency with control
22 for channel A and B will be transmitted to channel
C and D, regardless of switch 18 position (HP/ Lin/
TP), no matter if channel A and B are used as highpass,
full range or lowpass, the signal is always transmitted
as lowpass to channel C and D. Adjust the desired frequency
of the transmitted signal with control 22. Due to
the transmission of lowpass to channel C and D it is possible
to build a bandpass with a bandwidth of 15 Hz up
to 7 kHz.
Социальные закладки